KTM/Husqvarna 690 / 701 Enduro / Supermoto 12,000 Mile Service

KTM/Husqvarna 690 / 701 Enduro / Supermoto 12,000 Mile Service

$420.00

Elite Motorsports
1400 E Eisenhower Blvd
Loveland, CO

Service Description

Performing regular service at the factory recommended service intervals is critical to ensuring the long-term reliability of your motorcycle. This small investment will allow our technicians to inspect your bike for any potential warning signs and improper adjustment before it leads to costly repairs.

12,000 Mile / Annual Service

  • 5-Hours @ $104.00 per hour

690 / 701 ENDURO / SUPERMOTO (12,428 MILES)

  • Check that the electrical equipment is functioning correctly.
  • Read out the fault memory using the KTM diagnostics tool.
  • Check the measured service values with the KTM diagnostics tool.
  • Change the engine oil and filter, clean the oil screens.
  • Check the front brake linings.
  • Check the rear brake linings
  • Check the brake discs.
  • Check the brake lines for damage and leakage.
  • Check the rear brake fluid level.
  • Check the free travel of the foot brake lever.
  • Check that the shock absorber and fork are leak tight. If necessary and depending on use, service the fork and shock absorber.
  • Check the swingarm bearing.
  • Check the wheel bearing for play.
  • Check the tire condition.
  • Check the tire air pressure.
  • Check the spoke tension.
  • Check for rim run-out.
  • Check the chain, rear sprocket, engine sprocket, and chain guide.
  • Check the chain tension.
  • Grease all moving parts (e.g. side stand, hand lever, chain, ...) and check for smooth operation.
  • Clean the dust boots of the fork legs.
  • Check the brake fluid level of the front brake.
  • Check the play of the steering head bearing.
  • Change fuel screen.
  • Change the spark plug.
  • Check the valve clearance.
  • Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks, and incorrect routing.
  • Check the antifreeze and coolant level.
  • Check the cables for damage and routing without sharp bends.
  • Change the air filter. Clean the air filter box.
  • Check the fuel pressure.
  • Check the CO adjustment with the KTM diagnostics tool.
  • Check/rectify the fluid level of the hydraulic clutch.
  • Check the screws and nuts for tightness.
  • Change the front brake fluid.
  • Change the rear brake fluid.
  • Check the headlight setting.
  • Check that the radiator fan is functioning properly.
  • Final check: Check the vehicle for roadworthiness and take a test ride.
  • Read out the fault memory using the KTM diagnostics tool after a test ride.
  • Make the service entry in the KTM Dealer.net and in the Service and Warranty Booklet.